Are you looking to buy a Sunlu Filadryer S2 in Australia?
S2 has an extraordinary design: heating module, 360 ° constant temperature, fast-drying, and a large screen for easy operating.
Phaser FPV ultimate filament drying guide
Dry your filament with the Sunlu Filament Dryer & use it while printing with a Dryer Mount. You can monitor the humidity in the Sunlu Dryer with our Humidity Sensor & Humidity Mount When printing is finished, store it in the airlock bags and remove air with NanoVac Pump. You can then place a Humidity Sensor in our spool adapter and have a good gauge of humidity on the spool when you go to print again. It may require drying again for optimal results however it won't take as long because of the storage in the bags. You can even stack all your filament on top of each other once they are in the airlock bags. Be careful of any sharp filament ends and certain spools that have sharp areas as this can puncture the bags.
Clogged nozzle? Not a problem! Check out our nozzle cleaning filament!
Product specifications
- Product size: 265(L) X274(W) X 118(H) mm
- Maximum capacity: φ210*85（H）mm\
- Net weight: 1190g (Including power adapter)
- Working environment:
- A) Environment temperature: 20℃~35℃
- B) Relative humidity: ≤90%
- Temperature setting range: 35℃~70℃
- Power adapter specification:
- A) Input specification: AC 100V~240V，50/60Hz
- B) Output specification: DC:24V±1.2, 2A
- Standby Power: 0.05W
- Maximum working current: 1.9A
- Maximum working power: 48W
- LCD display screen: 6.4-inch LCD displaySuitable for filament diameters: 1.75mm/2.85mm
Browse more
- Browse all Filament Dryers
- Browse all Sunlu