Are you looking to buy CLRACING Heli-Nation Talon F7 - We Ship Australia Wide!
The Heli-Nation Talon F7 20x20 Flight Controller is a fantastic FC perfect for your quad. With an F7 processor and 8S capable, Talon is a great 20X20 with STM32F722RET6 216MHz processor. Built in Betaflight OSD, 6 UARTS, and dedicated LDOs for cleaner gyro and OSD signals makes Talon F7 the most powerful 20X20 FC on the market. One of the features Talon F4 customers praised is the choice of using the 8 pin harness or direct soldering motor ports to the ESC. Heli-Nation has kept that option, while still adding even more features, by letting customers remove the plastic connector to reveal motor ports. The 8 pin harness will be a direct pinout for the Aikon 20X20 6S ESC!
**WARNING! If you remove the JST connector to direct solder, the pinout is not the same as the JST connector. Please use the diagram below to see the correct pinout. Please pay attention to VBAT and Ground!
Features
- MCU: STM32F722RET6 216MHz
- MPU 6000
- Built in Betaflight OSD
- Up to 8S (36V) direct battery power
- Buzzer pads for external buzzer
- Build in voltage monitoring resistor
- 5V 2A BEC
- Dedicated LDO for gyro for cleaner gyro signal
- Dedicated LDO for OSD for cleaner OSD signal
- Led strip shares 5V with 5V/2A BEC
- 6 UARTS: UART1,2,3,4,5,6
- Built in camera control pin with resistor and capacitor
- 4 Full UARTS with RX/TX pins
- Logical pin layout for the cleanest build possible
- 8 pin 4 IN 1 ESC plug (Direct solder to motor ports underneath)
- Remap able LED pad for additional motor output
- 16M Blackbox flash chip
- TX3 & RX3 can be used for I2C for external compass
- 5V or 3.3V selectable receiver power
- 5V, VBAT selectable VTX and CAM power
Includes
- pin connector (Aikon compatible)
- 8 grommets M4 to M3
- M3 to M2 nut adapters
- M3X5 standoffs
BROWSE MORE
Browse all CLRacing
Browse all Flight Controllers
Browse all Drone Electronics