Are you looking to buy an LDO Toolhead PCB in Australia?
For use in conjuction with the breakout board and Toolhead Cable by LDO
The Toolhead PCB
The toolhead PCB is based on hartk's toolhead PCB design. The main purpose of the toolhead PCB is to combine all the signals and wires (e.g. thermistors, fans, hotend) on the toolhead PCB into a single cable. Compared to the orignal hartk design, the LDO PCB has a few minor differences:
- The hotend cartridge connector is screw terminal instead of a microfit 3 connector.
- The onboard thermistors use NTC10K thermistor, more info here.
Apart from the above mentioned differences our PCB has the same shape and mounting hole positions, and the 14 pin microfit pinout is 100% compatible with the original hartk PCB.
Port Descriptions
The table below briefly describes the purpose of each port located on the toolhead PCB.
PCB Label | Name | Connector | Description |
HEF | Hotend Fan | JST-XH-2P | Fan port for cooling the hotend heatsink. Note that only 24V fans are compatible |
PCF | Part Cooling Fan | JST-XH-2P | Port for part cooling fan. Note that only 24V fans are compatible |
HE0 | Hotend Heater | Screw Terminal | Port for hotend heater cartridge. |
TH0 | Hotend Thermistor | JST-XH-2P | Thermistor port for hotend |
XES | X Endstop | JST-XH-2P | X endstop port. Only used in Switchwire builds, unused in V2 and Trident. |
PROBE | Probe | JST-XH-3P | Probe port. Accepts 24V inductive probes, also compatible with klicky probes. |
E-STEP | E Stepper Motor | JST-XH-4P | Extruder stepper motor port |
Connection Diagram
Browse more
- Browse all LDO
- Browse all Voron parts and accessories