Are you looking to buy a SpeedyBee F7 Mini 35A Flight Controller Stack in Australia
SpeedyBee F7 Mini 35A 3-6S 8-bit Flight Controller Stack
Specifications:
- Product Name SpeedyBee F7
- MCU STM32F722
- IMU(Gyro) MPU6000
- USB Port Type Type-C
- Barometer N/A
- OSD Chip AT7456E chip
- BLE Bluetooth Supported. Used for Flight Controller configuration (MSP should be enabled with Baud rate 115200 on UART 6)
- Flash FC Firmware Wirelessly Not supported. Please update firmware for this FC on the PC
- Download/Analyze Blackbox Not supported. Please download and analyze Blackbox data on the PC
- DJI Air Unit Soldering Pads Supported
- Flash(for BlackBox) 8MB
- Current Sensor Supported, Scale=250 Offset=-500
- BetaFlight Camera Control Pad Yes(CC pad)
- Power Input 3S - 6S Lipo
- 5V Output 6 groups of 5V output, five +5V pads and 1 BZ+ pad( used for Buzzer). The total current load is 2.5A.
- 9V Output 2 groups of 9V output, the total current load is 2A.
- 3.3V Output Supported. Up to 500mA current load.
- ESC Signal Pads M1 - M4
- UART Full UART * 3(UART1, UART2, UART3)
- ESC Telemetry UART R4(UART4)
- I2C Not supported
- LED Pad Used for WS2812 LED
- Buzzer BZ+ and BZ- pad used for 5V Buzzer
- BOOT Button Used to enter DFU mode
- RSSI Input Not supported
- SmartPort Use any TX pad of UART for the SmartPort feature.
- Supported Flight Controller Firmware BetaFlight(Default), EMUFlight, INAV
- Firmware Target Name SPEEDYBEEF7MINI
- Mounting 20 x 20mm, 3.5mm hole diameter
- Dimension 30 x 30 x 7.5mm
- Weight 5.7g
- Product Name SpeedyBee 35A BLHeli_S Mini 4-in-1 ESC Specs
- Firmware BLHeli_S JH40
- Continuous Current 35A * 4
- Burst Current 45A(5S)
- ESC Protocol DSHOT300/600
- Power Input 3-6S LiPo
- Power Output VBAT
- Current Sensor Support (Scale=250 Offset=-500)
- Mounting 20 x 20mm, 3.6mm hole diameter
- Dimension 35 * 35 * 5.5mm
- Weight 7g
Browse more
- Browse all Flight Controllers
- Browse all Stack Combos
- Browse all SpeedyBee